Silver Pulsar
Combination Colloidal Silver Maker and "Zapper"
By Robert C. Beck
The ZBB5 Silver Pulser is based upon Dr. Bob Beck's experimental
combination blood electrifier and colloidal silver generator. Features include a
built-in Constant-Current circuit for the Ionic/Colloidal Silver output, an LED
Light that indicates when the current through the stimulator electrodes is
correct and a long-lasting electrode headset. The Silver Pulser is sometimes
confused with Dr. Hulda Clark's Zapper but these two instruments function in
different ways, operating under different principles. The Hulda Clark Zapper
delivers particular Rife frequencies to the body in the range of 30 thousand
cycles as its basis of operation, whereas the Silver Pulser is based upon a 1992
U.S. medical research and design patent that describes the delivery of voltage
and current into the bloodstream using a set of wire electrodes in order to
neutralize viruses and bacteria.
The Silver Pulser is housed in an attractive new custom plastic box,
with a built-in compartment for the 9 Volt battery. A slide-off lid allows you
to change the battery easily. A Thumbwheel Switch Control Knob turns The Silver
Pulser on and off and varies the intensity of the "Bio-Stimulator Probe" output.
A Green LED Light comes on when the Silver Pulser is turned on. Flashing Yellow
LED light on the unit indicates there is a correct "Bio-Stimulator" output and
comes on only when current is flowing. Red LED Light indicates low battery. In
addition, an Orange LED light is used for the Ionic-Colloidal Silver generation.
The Orange LED Light comes on when current through Silver Wires is correct.
The Silver Pulser has one 6 pin DIN style jack for plugging in the Fine
Silver Wires, another for the copper Bio-Stimulator Probes. A second jack is
used for hooking up an AC-DC Wall Adaptor so you don't have to go through
batteries. We also include Cotton Sleeves to put over the Bio-Stimulator Probes
for helping to maintain a good connection when moistened. (Hint: Use a Salt
Water solution or a conductive gel for better conductivity!) The Silver Pulser
is packaged in a custom soft carrying case for easy storage.
Each Silver Pulser is a
professionally designed quality instrument, thoroughly tested on an oscilloscope
and is guaranteed to operate as per the specifications in Dr. Bob Beck's
research. The Silver Pulser is a dual-function instrument, being both a Bio-Pulser
/ Zapper and Ionic Colloidal Silver Generator. The Silver Pulser generates the
finest quality Ionic Colloidal Silver at a rate of 3-5 ppm (part per million) in
20 minutes per 8 to 16 ounces of distilled water, with an Ionic Colloidal Silver
particle size that is mostly ions, with colloidal particles in the range of
0.005 - 0.015 microns (Verified on a Scanning Electron Microscope). It has a Bi-Phasic
output frequency of ~3.92 Hertz (cycles per second) at a nominal voltage of 33
volts DC peak per cycle. Peak to peak voltage is 66 volts. Unit uses a single
9-volt battery.
|
 |
The Silver Pulser
Model ZBB5 Operating manual
Silver Wire electrode holder Two
silver wires (.999 fine silver)
High grade Gold plated stimulator
probes Two Velcro / Neoprene
straps Two pair cotton probe
sleeves Scrubber pad for
cleaning silver wires Bag
containing Celtic Sea Salt
One 2 oz. dark glass dropper bottle
Custom soft storage case 3 year
parts and labor warranty Silver Pulser is non-refundable
|
 |
|
Colloidal Silver Features
Making high-quality colloidal silver
is now easier than ever. The Silver Pulser comes with a custom
retainer that is placed on top of your glass of water or other
container. The silver wires extend straight down into the water and
are held in place by a spring-loaded clip. Silver wire length is
adjustable to fit the depth of your glass or container. The silver
wires are easy to remove and replace. During the process of making
colloidal silver, the positive silver wire loses silver and
gradually shrinks in diameter. By switching the positive and
negative wires around, the usable life of the wires is doubled and
you can make twice the amount of colloidal silver. |
|
Silver Pulser
Specifications
-
Output Voltage
at Gold Stimulator Probes: 31 volts (peak per cycle, 66 volts
peak-peak)
-
Output Current
at Gold Stimulator Probes: ~12 milliamps maximum when probes
shorted and Control Knob on full intensity.
-
Output Voltage
at Colloidal Silver Wires: 31 Volts DC +/- 1 Volt constant
voltage
-
Output Current
at Colloidal Silver Wires: 1.0 milliamps Constant-Current Output
-
Colloidal
Silver Production: 3-5 parts per million in two hours in 8 to 12
ounces of distilled water
-
Colloidal
Silver Particle Size: mostly ionic with colloidal particles in
the range of 0.005 to 0.015 microns
-
Silver Probes
can make many gallons of 3 to 5 parts per million colloidal
silver when used as directed
-
Optional Input
Voltage: 6-12 volts DC @500mA wall transformer/adaptor, auto
battery or solar panel
-
One standard
9-volt alkaline battery (included)
-
Bi-phasic at
~3.92 Hertz +/- 1 Hz
Notice:
The Silver
Pulser is not intended or recommended as an alternative to accepted
modes of first aid, or medical intervention, or treatment. It is not
intended to be used as a medical device for humans, or in the
diagnosis, prevention, treatment, cure, or mitigation of any
illnesses or diseases in humans. The Silver Pulser is an
experimental electronic research instrument for use by qualified
individuals. All cases of injury or disease must be diagnosed and
treated by a licensed health professional.
|
$195
Quantum Healing Package
Specials |
